Home > Industry > Content

Daily maintenance of twin screw extruder

Dec 12, 2017


One, after 500 hours, the gearbox will have the iron dust or other impurities, so the gear should be cleaned and the reducer should be replaced at the same time.

Two, after a period of time, a comprehensive examination of the extruder should be carried out to check the tightness of all the screws.

Three, if the power is suddenly cut off in the process of production and the main drive and heating stop, when the power supply is restored, it is necessary to reheat each section of the barrel to the prescribed temperature and keep it for a period of time, then it can activate the extruder.

Four, if the steering full of the instrument and pointer is found, it should be checked whether the contact of the thermocouple equilateral line is good.

For more on these themes, see below. 

27.jpg   tpu.jpg   p201703091112397995802.jpg

             Underwater Pelletizing                             TPU Twin Screw Reaction Extrusion Line                 PPR/PP/PERT Pipe Extrusion Line

pvc.jpg   pvc2.jpg  14.jpg

U-PVC/C-PVC Pipe Extrsion Line     PVC/PP/PE/PS Extrusion Sheet(Panle)Production Line            HDPE Pipe Extrusion Line